Cisco Packet Tracer Lab Test: CCNA First week Test Paper.Access Mobile Webcam, Microphone and Get Mobile Location using Kali Linux using STROM Breaker.CCNA Test Paper: Ethical Hacking Tuition Center.Storage Management Training Syllabus: Ethical Hacking Tuition Center Jaipur.CCNA LAB Test Paper: using Cisco Packet Tracer.Data Center Lab Test Paper : Including Linux Servers ,LVM,RAID,Loop Devices and Swap.Sending 5, 100-byte ICMP Echos to 7.0.0.1, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 0/0/1 ms Sending 5, 100-byte ICMP Echos to 6.0.0.1, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 0/4/20 ms ![]() Sending 5, 100-byte ICMP Echos to 5.0.0.1, timeout is 2 seconds: Success rate is 100 percent (5/5), round-trip min/avg/max = 14/38/52 ms Sending 5, 100-byte ICMP Echos to 4.0.0.1, timeout is 2 seconds: Sending 5, 100-byte ICMP Echos to 3.0.0.1, timeout is 2 seconds: Sending 5, 100-byte ICMP Echos to 2.0.0.1, timeout is 2 seconds: via 1.0.0.1, 00:00:26, FastEthernet0/0ħ.0.0.0/8 directly connected, Loopback3 Now check every interfaces including loopback interfaces by pinging ip assigned on each loopback interfaces: R1#ping 2.0.0.1 R2# See RIP Databases on Router R2: R2#show ip rip database Let’s check Router R2 interfaces ip addresses: R2#show ip interface briefĬonfigure Routing RIP on Router R2: R2#config terminal R1# Configure IP ADDRESS on INTERFACES OF ROUTER R2: Router>enable R1(config)#exit Now see RIP Routing DATABASES on Router R1: R1#show ip rip databaseġ.0.0.0/8 directly connected, FastEthernet0/0 Remember you also have to include network created by Virtual Interfaces what we call Loopback interfaces. Vlan1 unassigned YES unset administratively down down Interface IP-Address OK? Method Status ProtocolįastEthernet0/0 1.0.0.1 YES manual up downįastEthernet0/1 unassigned YES unset administratively down down ![]() R1(config-if)#exit See or verify router interface ip address using below command: R1#show ip int br R1(config-if)#exit R1(config)#int loopback 3 Now go to loopback Interface and assign ip address on it. Router>enableĮnter configuration commands, one per line. Here I am going to assign ip address on router real interfaces and also going to create virtual interfaces and loopback interfaces and assign ip address on loopback interfaces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |